Victorian Greenhouse of Bath

We take care of the installation for you.

ACCESS: After production in the workshops, we deliver and install the Greenhouse. A clear route to your prepared base is required, so that the panels can be delivered without any height, width or tight corner restrictions. Please bear in mind our pre-built panels arrive in large heavy complete sections.

Nothing is beyond our capable crew but we need to know in advance please if we have to remove rose arches for example if this is the only way in to access the site.

BASE: In advance of our arrival please prepare a firm and level base .

It should be large enough for the pressure treated bearers we supply for the building to sit on, please allow 1200mm (4 feet ) extra room all round the building especially if it is to be located in a corner or against fence for us to be able access to glaze and of course for you to be able to wash the glass down from time to time.

A Base plan will be sent on receipt of your order

Dwarf Wall Models

A Brickwork layout drawing will be provided where your own builder will be constructing the foundations and dwarf wall.

For all freestanding models

Pre prepare the site in advance our installation date

Either install a slab base which you may chose to have infilled completely

or the centre can be left open with soil or gravel.

Alternativly sink 6 concrete blocks flush with the ground and cement in place or use rapid set post mix to set them in. We will send a layout plan.

The pressure treated bearers will be anchored to the sub base, and the Greenhouse will be assembled and secured onto this pressure treated timber frame.

PARKING: Please advise us if there are any parking restrictions or if vehicle access is not possible or if we have to carry the building further than 100mtrs.